kLite Dual Qube - Front and Rear Safety Blinker
The one, the only . . . Dynamo powered front and rear safety blinker combo.
Get rid of your annoying battery powered safety blinkers and switch to kLite Qube! Draws a minimum of current and includes capacitive storage so it continues to flash for a few without charge input. Draws so little current, in fact, that if you plan to use it with a charge battery, it has to be one that allows a trickle of current. Includes three sizes of mounting hardware for different frame placements.
Perhaps most interestingly, the device draws its inspiration from space docking trials, which have reportedly observed that it’s easier to judge distance with a light that blinks at a random periodicity rather than a uniform one.
The Qube flashes a set of short flashes followed by a longer one, and there is randomness in the blinkage. That makes it uniquely different from virtually every blinker in the market. Safety with a touch of space age tech—pretty much a perfect reason to justify this purchase to your SO. Wait, did you just say that out loud?
Even more details:
—lenses are clear but the rear flashes red and the front flashes white
—USB cable - see pictures for length. From USB to the end of the rear blinker, approximately 36 inches. From the USB to the end of the front blinker, it's about 22 inches. If you need further extension, purchase a short male to female USB extender.
—Optimized for use with kLite USB chargers; will not auto start from some USB dynamo chargers
—Plugs into USB output or USB splitter, can not be connected directly to dynamo hub.
—ULTRA low power drain
—Anti-glare optics: no blinding following riders, high visibility for vehicle at distance
—100% waterproof / Dunk proof
—Will not run from USB cache battery, unless it has LOW power mode, as its so low power, cache will just shut down and not recognize the low, intermittent drain from the Qube.
—optimized for the “always on” kLite wiring loom
—Produced by kLite in Australia